The heating of nozzle in injection machines is still today a big problem owing to the costs incidence and subsequent stops of the production process.

Hitco analyzed a large series of cases causing an early failure, most of them due to plastic leakage impregnating the heater and causing a range of effects as:

·         Carbonization of material near electrical connection which causes short circuit.

·         Penetration of material into the heater will lead carbonizing it. It causes the loss of insulation due to perforation of the element.

·         Damage to the structure of the element using tools for making the attempt of removing heater covered by plastic element.

·         Tearing of the feeding cables, which can arise both making the above action and careless during installation of the molds.

We take care particularly of

• Mechanical Sturdiness
• High resistance of the cable to tears and accidental impacts.
• Sealed construction against plastic material penetration
• Protection of the connection point between resistance circuit and feeding

Besides, high specific power reachable with Tubular Band Nozzle Heater for High Temperatures, up to 15 w/sq.cm on the nozzle and its excellent mechanical characteristics giving a consequent unlimited wrapping possibilities of the tubular element, it allow to solve most complicated heating problems when existing the need of a big heat contribution in short time and at controlled temperature.

Whole ranges of nozzle heater are manufactured in accordance with safety rules and they are submitted to a final safety and quality tests according to the European standards.
On request we can supply relevant certification for each heater.